Better to have a knife with replaceable blades. As soon as you feel difficulties in cutting cover – change the blade. Before further fixing skirting boards may need to lie down carpet day or two, so he straightened up. Once the carpet lie down, you can start fixing skirting. 4.

ESTABLISHES the plinth. It is quite simple. First, take out of the skirting strips, which cover the cable channel (they are then easily be put in place). Decompose the baseboard along the wall and see whether their crop. If necessary, cut the pieces of skirting the desired length. Further, it is more convenient to work together. One supports the plinth, the other drill holes. The procedure is as follows: – presses the baseboard to the wall and the floor (so it is slightly pressed cover) – hammer drill a hole in the baseboard and the wall.

In the baseboard is drilled a hole where it then will not be seen – under the bar, hiding the cable channel – with the resulting hole looks like dust and pushes back the plastic plug (of course, drill diameter should match the diameter of the dowel) – insert a dowel screw and screwdriver to twist it – go to the place of the next hole and repeat all the manipulations. At the end of attachment vacuum cleaner (preferably old) "sucks" construction dust from the places where they were drilled. Please note the following: – If you're going to run a baseboard with a phone cable or antenna connector or just a thick cable, it can be difficult. Through corners or baseboards connect this cable is almost impossible to push through. Out of the situation in two ways: to lay the cable fastening baseboards, ie together with their installation. Or perhaps laying the cable after installing baseboards, but by loosening the mounting screws and extreme pulling over.